Racing this Thursday 18th Oct (RC, SC, F1)
Posted: Mon Oct 15, 2018 8:48 am
Hi Guys,
FRC will be open for practice, testing and racing from 7:30 PM this Thursday (18th October) for our 2018 Group B classes - Rally Car (RC), Slot.It Challenge (SC), Formula 1 (F1).
We're going to be running to our new schedule, with an earlier finishing time, so plan to be here as early as possible after 7:30 PM. Here's the basic plan:
Don't forget to bring along some refreshments.
Reality Checks
Rally Car:
Slot.It Challenge:
Formula 1:
See you on the circuit...
Gordon
FRC will be open for practice, testing and racing from 7:30 PM this Thursday (18th October) for our 2018 Group B classes - Rally Car (RC), Slot.It Challenge (SC), Formula 1 (F1).
We're going to be running to our new schedule, with an earlier finishing time, so plan to be here as early as possible after 7:30 PM. Here's the basic plan:
- Free practice and testing up to 8:30 PM
- 8:30 PM - Technical Inspection (excluding IROC classes). Cars will be moved to the parc fermé location after they are inspected and comply with the requirements.
- Qualifying followed by racing. Drivers not ready when called to grid will be replaced by any standby drivers who are ready.
- Post-race Technical Inspection (if required).
- After racing - Packing up and liming/old talk (but not too late!).
- Rally Car - If visible, interior must have both driver and navigator figures (heads minimum); no traction magnets; "Magnet-effect" motors are not allowed.
- Slot.It Challenge - Group C Slot.It cars only; single standard Slot.It "non-race" magnet (the one with the grooves); Slot.It tyres.
- Formula 1 - F1 or F1-type body (must be painted - no unpainted bodies allowed); 63mm maximum width; any motor up to 18,000 RPM; USD rule - magnets must be positioned at least 5.5mm ahead of rear axle; wheels 14mm max diameter without tyres; tyres at least 18mm diameter; rear tyres at least 11mm wide.
- All classes that stipulate the USD rule - Cars must drop away from a C7016 Scalextric Single Lane Half-straight 175mm that is held still (no shaking) in an upside-down position. Any weight added to the car must be positioned within 2.5" (64mm) and ahead of the rear axle.
Don't forget to bring along some refreshments.
Reality Checks
Rally Car:
Slot.It Challenge:
Formula 1:
See you on the circuit...
Gordon